Time Mode - Garland PRESS 491 FLAE Manuel D'instructions

6. Set the hour. Pressing the "SET" button
increases the hours and pressing the "MODE"
button decreases the hours. Once the hour is
set, press the "CHECK" button to memorize and
go to the next step.
7. Now adjust the minutes of the hour in the
same way using the buttons "SET" to increase
and "MODE" to decrease the minutes. Once
the minutes have been set, press "CHECK" to
memorize the minutes and go to the next step.
8. Now set the stop time of the pump. The
message will appear on the screen:
Save
Press the "SET" button to set the stop time and
the display will change to:
Save
9. Set the hour. Pressing the "SET" button
increases the hours and pressing the "MODE"
button decreases the hours. Once the hour is
set, press the "CHECK" button to memorize and
go to the next step.
10. Now adjust the minutes of the hour in the
same way using the buttons "SET" to increase
and "MODE" to decrease the minutes. Once
the minutes have been set, press "CHECK" to
memorize the minutes and go to the next step.
11. The configuration summary with the start and
stop times will now appear on the screen:
Time On
00:00
Set Exit
00:00
+ -
00:00
00:00
This screen will remain for a few seconds and
then the screen will indicate "Time Mode"
indicating that the pump is in Time Mode and
that it will start and stop according to the
confirmation.
6.4. VERIFICATION POINTS AFTER START-UP
This machine has two safety systems against
overload, one in the automatic pump and the other in
the pump.
The automatic pump is designed to withstand currents
of up to 10 Amps. If the pump automatic detects a
current greater than this value, it will disconnect the
pump and the alarm indicator (ALARM) will come on.
If this happens, check the reason for this excessive
expense and, after solving the problem, press the
"RESTART" button.
This machine has a safety switch that will disconnect
the machine in case of overload due to excessive
work. If you detect that the machine does not start, it
may be because the safety switch has been activated.
In this case unplug the unit and wait 15 minutes
before restarting the machine.
6.5. PROTECTION AGAINST OVERLOAD
This machine has a safety switch that will disconnect
the machine in case of overload due to excessive
work. If you detect that the machine does not start, it
may be because the safety switch has been activated.
In this case unplug the unit and wait 15 minutes
before restarting the machine.
31/92

Time Mode

English