Functions; Setup; Wireless Setup For Mobile Telephone; Installing Neckloop - Clarity CE50 Mode D'emploi

Functions

R1: On/off switch, answering button, and Bluetooth®
indicator
R2: Volume button +/- (up/down)
R3: Bluetooth and volume level 1 indicator
R4: Volume level 2 indicator
R5: Battery and volume level 3 indicator
R6: Volume level 4 indicator
R7: Volume level 5 indicator
R8: Headphones jack
R9: Neckloop jack
R10: Neckloop
R11: Charging jack
Microphone
R12:
Button/diode/jack
R1 • Power on (hold for up to five seconds)
• Power off (hold for up to five seconds)
• Answering and ending mobile telephone calls
• Blue light: Bluetooth active
• Blue blink: Incoming call
R2+ (up) • Volume up
R2- (down) • Volume down
• Reject mobile telephone call (hold for two seconds)
R3 • Blue blink: Bluetooth not connected
• Green light: Volume level 1
R4 • Green light: Volume level 2
R5 When in use
• Red blink: Low battery
• Green light: Volume level 3
When charging
• Red light: Charging
• Green light: Fully charged
R6 • Green light: Volume level 4
R7 • Green light: Volume level 5
R8 • Jack for headphones
R9 • Jack for neckloop
R10 • Neckloop
R11 • Jack for charger
R12 • Microphone
R9
R7
R5
R2
R10
R3
R11
Functions
6

Setup

Wireless setup for mobile telephone

R12
Establishing a wireless connection between the Bluetooth mobile telephone and the CE50 HearIt Mobile
1. Turn CE50 HearIt Mobile on by holding down the receiver button R1 for up to five seconds.
2. Enter the mobile telephone menu to allow the mobile telephone to search for available Bluetooth devices.
R8
3. Select the Bluetooth entry "HearIt Mobile".
4. Enter the pass code into the mobile telephone (0000). Select "connect." A short beep will be heard in the hearing
aid or in the headphones.
R1
5. Once the wireless connection is established, receiver indicator R3 stops blinking blue.
R6
R4
HearIt Mobile
R3
2
3

Installing neckloop

In order to use CE50 HearIt Mobile with hearing aids in T-position (telecoil), the hearing aid must be equipped with a
telecoil fitted by a hearing care professional.
Installing neckloop
1. Detach neckloop R10 from receiver jack R9 by pulling the loop wire.
2. Place the CE50 HearIt Mobile on the chest and place loop wire around the neck.
3. Reattach neckloop R10 to receiver jack R9.
4. Switch hearing aid to T (telecoil only) or MT (microphone and telecoil simultaneously) position.
NOTE: Neckloop and T/MT function on hearing aids.
R9
1 2
Please note:
• Once a wireless connection between CE50 HearIt Mobile
and a Bluetooth unit has been established, the units will
automatically connect when they are within range of each
other.
• During telephone conversations, the receiver indicator R1
5
will illuminate blue indicating that the wireless connection
is active.
R9
R10
3
7
ENG
Please note:
• Connecting headphones
to the headphones jack R8
disconnects the signal to the
neckloop.