Ontrol - Neptronic NEP AFEHR80T Guide D'utilisation

2. Controls
(cont'd)
2.2 DTG Main Control
H
OW TO SET THE RELATIVE HUMIDITY
Setting the relative humidity level allows to select the maximum desired indoor humidity level (in
percentage). This value will be used to start the dehumidistat override (air exchange on minimum
or maximum speed).
Two lines are flashing to
show that OFF¹ is in standby
(default configuration setting).
(cont'd)
(RH)
RECIRCULATION
OR
The LCD screen will show one of these configurations:
OR
Recirculation
turning, rE flashes and MIN
label appears to show that
RECIRCULATION on low
speed² is in standby.
LEVEL AND CHOOSE BETWEEN
IN STANDBY
Press and hold OK for 3 sec. to
3 sec.
access the settings menu.
The backlight will be activated
during the entire procedure.
The Relative humidity arrow and
value will flash
(default setting: 45%).
OR
Press OK button to accept the new
value and go to next setting.
OR
arrows are
Use UP or DOWN arrow to
OR
see all 3 configurations.
6
OFF
IN STANDBY
Use the UP or DOWN
arrow to change the value.
The value changes by 1%
increments. Lowest value:
30%. Highest value: 55%.
Still flashing.
Recirculation arrows
turning, rE flashes and MAX
label appears to show that
RECIRCULATION on high
speed² is in standby.
are