READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY, SERVICE OR
USE OF THIS FAN. FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN
SERIOUS PERSONAL INJURY AND / OR PROPERTY DAMAGE.
THIS IS A FAN - NOT A TOY!
WARNING
TO REDUCE THE RISK OF
PERSONAL INJURY AND ELECTRIC SHOCK,
FANS SHOULD NOT BE PLAYED WITH OR
PLACED WHERE SMALL CHILDREN CAN
REACH IT.
To guard against electric shock
WARNING
while operating, do not allow fan
to come in contact with other grounded objects
such as pipes, radiators, etc.
Risk of fire, electric shock, or
WARNING
personal injury when performing
service or maintenance. Unplug or disconnect
the fan from the power supply before servicing.
CAUTION Automatically
WARNING
Operated Device - To Reduce
The Risk Of Injury Disconnect From Power
Source Before Servicing
To Reduce The Risk Of Fire
WARNING
Or Electric Shock, Do Not Use
This Fan With Any Solid- State Speed Control
Device.
To Reduce The Risk Of Electric
WARNING
Shock And Injury To Persons, Do
Not Use In a Window.
To Reduce The Risk Of Electric
WARNING
Shock, Do Not Expose To Water
Or Rain. This unit is designed for indoor use
only.
Do not operate any fan with a
WARNING
damaged cord or plug. Discard
fan or return to an authorized service facility
for examination and/or repair. Do not run cord
under carpeting. Do not cover cord with throw
rugs , runner, or similar coverings. Do not route
cord under furniture or appliances. Arrange cord
away from traffic areas and where it will not be
tripped over.
© 2015, Pinnacle Products International, Inc.
Installation work and electrical
WARNING
wiring must be done by
qualified person (s) in accordance with all
applicable codes and regulations.
When servicing or replacing a
WARNING
component requires the removal
or disconnection of a safety device, the safety
device is to be reinstalled or remounted as
previously installed before operating this fan.
Use this fan only in the manner
WARNING
intended by the manufacturer.
If you have any questions, contact Customer
Service at 800-641-6996.
- Before operating always check fan for loose
or damaged parts. Inspect power cord for any
damage. Never use fan if any parts are
damaged or missing. Never use fan without
safety guards attached.
- Operate only on 120 volt 60 Hz (cycle) current
with a minimum of a 15 amp circuit.
- When used with an extension cord, use only
cord of proper size (Amp rating), UL listed, and
with receptacle to accept three prong grounded
plug furnished on the fan's power cord. Always
keep power cord and extension cords away
from heat, oil, and sharp edges. Inspect cords
periodically and replace if damaged.
3