ACV 2GO Active BT1 Manuel page 8

60℃) which may affect the headset's operations although it is fully
charged.
 Do not dispose of the headset into a fire or water article and could be
dangerous.
Turning On The Headset
In OFF MODE, press and hold MFB for 1 second, until you hear "Power
on", the indicator light turns blue for 6 seconds, then the headset will enter
into ON MODE.
Turning Off The Headset
In ON MODE (except call state), press and hold MFB for 3 seconds, until
you hear "Power off", the indicator light turn red for 1 second, then the
headset will enter into OFF MODE.
Note: Headset isn't connected with any devices within 7 minutes (including
1 minute searching time), it will automatically turn off.
Pairing Your Headset With A Bluetooth Phone
 Ensure the headset is off, and the distance between your headset and
phone is within 1 meter to activate the Bluetooth function on the phone.
 Press and hold MFB until the indicator light flashes blue and red
alternately and could hear "Bluetooth Mode" as PAIRING MODE.
 Search Bluetooth devices (see the user guide of your phone for
instructions).
 Select headset "2GO BT2" from the found devices list of the phone.
 After waiting for a few seconds, enter into pairing code "0000", you could
hear "connected". It is connected successfully. (If the pairing cannot be
completed whithin 1 minute, the headset will enter into disconnected
standby mode, press MFB will enter into Pairing Mode again).
 Ensure the distance between your headset and phone is within effective
distance and there is no obstacle, you can use the headset to answer
calls and do other operations.
 When the headset is off, it will connect the paired phone automatically if
you turn on the headset again within operation range.
Answering A Call
When a call is coming, you could hear the ring tone and incoming call
numbers voice prompt, you can answer it with the ways as follows:
Method 1: Press MFB once.
Method 2: Answer the call with your phone.
Ending A Call
You can end the call you are answering with the ways as follows:
Method 1: Press MFB once, you will hear "Hang up".
Method 2: End the call with your phone.
Rejecting a Call
Press and hold MFB for 2 seconds to reject the call, you will hear "Call
Rejected".
Adjusting The Volume
In call or playing music state, long press V+ or V- to adjust the volume.
When the volume up to maximum, you could hear "Volume Maximum".
When the volume down to minimum, you could hear "Di,Di".(There is no
any voice prompt when you adjust the volume in the call.)