ACV 2GO Active BT1 Manuel page 7

EN User Manual
Magnetic Bluetooth Headset 2GO BT1
Bluetooth headset should be used with the compatible devices which
support Bluetooth wireless technology.This allows you to make calls and
enjoy the music streaming at any time freely.
Please read this user manual carefully before using the headset, and also
read your device's user manual regarding the Bluetooth function, and pay
attention to those important safety and maintenance information. Please
keep the headset away from children.
Device view
1 Speaker
2 MFB-Button (Multifunction)
3 Volume up (+) / next song
4 Volume down (-) / prevou song
5 Microphon
6 Status LED
Status des Headsets
1 Pairing Mode
The headset can be searched, the indicator light flashes red and blue
alternately.
2 Not Connected
The headset is not connected with the device, blue light will flash twice
each 8 seconds.
3 Standby Mode
The headset is connected with the device, and no any other operations,
blue light will flash once each 6 seconds.
4 Call State
In a call state, the indicator light flashes blue once each 6 seconds.
5 Charging State
The indicator light turns red while being charged, and will turn off
automatically after being fully charged with blue light for 5 minutes.
Charging Your
 Prior to using the headset for the first time, please fully charge the
battery.
 Approximately 2 hours are required to fully charge the headset.
 The indicator light turns red while being charged, and will turn off
automatically after being fully charged with blue light for 5 minutes.
 When the battery's voltage below 3.3V, the speaker will prompt "Please
Charge" once each 30 seconds(the headset will switch off automatically
when the battery's voltage is less than 3.0V. You can hear "Power off").
Please charge the headset as above steps in time to prolong the
battery's useful life (Charging indication will be delayed for a few
minutes if the headset has not been used for a long time or the battery is
Specifications
 Check the charging device is suit to the headset.
 Use only the supplied charger to charge the headset, or
 Do not attempt to force open the built-in battery as this could damage
the headset.
 If left unused, a fully charged headset will lose its power automatically. It
is recommended to charge the headset each three months.
 Do not leave the headset in a too hot or too cold obey the validation for
this product or the maintenance condition (best between -20℃and