System Connection - Salora DVP7748DUO Mode D'emploi

System Connection

Powering and installation
Plug one end of the AC/DC power adaptor into the DC IN 9-12V jack on the right of the
unit, then plug the other end into the AC power receptacle. Please refer to the following
illustration.
SD
AV OUT
SD AV IN/OUT
If using car cigarette lighter adaptor to connect to the power:
Plug one end of the cigarette lighter adaptor into the DC IN 9-12V jack on the unit, plug
the other end into the car cigarette lighter socket.See illustration below.
SD AV OUT
SD
AV IN/OUT
Note:
1.Car cigarette lighter adaptor is not recommended to recharge the battery.
2.Car cigarette light adaptor can only be used when the car power supply is 9-12V.
3.The mains plug is used as the disconnect device, the disconnect device should remain
readily operable.
Car cigar ette lighter
6
Connecting to Unit A/B
1.Connect unit A and unit B with AV cable.
2.Connect the unit to power by AC/DC adapter or cigarette light adapter
3.Turn on these two units, insert a disc into the disc compartment of the main unit A,
press the IN/OUT key on remote control B to change Unit B to AV IN mode, then you
can see the same image on both units.
Please refer to the illustration below.
SD AV OUT
SD AV IN/ OUT
Connecting to TV
You can connect unit A or unit B with TV to enjoy high quality picture and stereo sound.
Please refer to the following illustration:
SD AV OUT
AV CABLE
VIDEO IN
AUDIO IN
Please use AV cable to connect the machine and the TV. Make sure it is connected
correctly.
Not supplied
7
TV