QEO FL 150H-G Mode D'emploi page 33

EN
SLEEP FUNCTION (STANDBY / MAN FUNCTION
Press this button once enter into the SLEEP mode. The instrument and the remote control are now in
standby mode. All values set will be stored. After restart the instrument will work with the same vales as
before.
Note: After 120 min. in standby function the laser automatically switches off.
Press the button again to re-active the instrument and the remote control.
Press the button long to enter into the MANUAL mode. Now the laser can be used in slope postion as
the instrument does not power off or re-levels automatically.
REMOTE CONTROL CHANNEL
Press this button short to select the remote control channel (ciruclarly from CH2 to CH 9 and from
A to F = 14 channels).
The channels of the remote can be changed in order to avoid that several units on one construction site
disturb each other.
REMOTE CONTROL
When the remote control is switched on the display automatically shows the channel that was selected
last. With the button the channels of the remote can be selected circularly from CH2 to CH9 and
from A to F (14 channels are available). If the display shows the remote has no connection to the in-
strument (the instrument is too far away, the connection is disturbed, the channels of the remote and the
instrument are not the same, the remote is switched off). shows that connection between the remote
and the instrument is okay.
With the on/off switch of the remote only the remote can be switched on and off - not the instrument.
The battery status indication of the remote only shows the battery status of the remote.
33