teutonia BeYou V2 Mode D'emploi page 6

Additional important safety notes
●
teutonia does not warrant the safety of
the current product in case of use of ac-
cessories and spare parts that are not
produced or approved by teutonia. In case
of use of such accessories and spare
parts the warranty will expire with immedi-
ate effect.
●
This pram is intended for only one child.
●
The seat or the carry-cot may not be used
in the car.
●
The pushchair seat is designed for a child
from birth up to 15 kg.
●
Carry-cots, prams and sports buggies may
be used only for transport and are not a
substitute for a cot or a cradle.
●
Always park the stroller/pram out of the
reach of children and do not allow chil-
dren to play in or with the stroller/pram.
●
Please never park the stroller/pram with-
out first applying the brakes. Make sure
that the brakes have locked properly.
●
The brakes should always be applied
when you sit or lift your child in and out of
the stroller/pram.
●
Always avoid parking on slopes.
● When using public transport take special
care to ensure the stroller/pram stands
firmly and safely.
●
Wheel the stroller/pram slowly and gently
up and down steps.
● Never place objects on the folding top.
●
The shopping net can be loaded to a
maximum of 5 kg (11 lbs). Please always
place heavy objects in the centre of the
shopping basket.
● When unfolding and folding the chassis
make sure that you do not pinch yourself
or others.
●
Make sure that no locks disengage while
carrying the stroller/pram over obstacles
(e.g. steps).
●
When adjusting the stroller/pram make
sure that your child is clear of moveable
parts.
10
●
The stroller/pram can be damaged or
destroyed by overloading, improper fold-
ing or use of unapproved accessories.
●
The foot rest is not suitable for transport-
ing heavy loads or a second child.
●
Before using the stroller/pram for the first
time: please remove the labels or tags
that DO NOT refer to safety instructions
or notes.
●
Never use the foot rest or the safety bar
to lift or carry the stroller/pram.
●
For babies up to an age of 6 month we
recommend only to use the backrest in its
lowest position .
Parking the pram/buggy
Attention: Under certain circumstances, the wheels
may cause discolouration of floor surfaces.
Foreign bodies (e.g. little stones) in the wheels must
be removed to prevent any potential damage to floor
surfaces. Extreme heat, in particular direct contact
with hot surfaces (e.g. in the car in summer) can lead
to permanent deformations on hollow cavity tyres.
Related complaints or claims for compensation will not
be recognized.
Cleaning the textile parts
To remove small stains, use a cloth dampened with clear
water and carefully clean the spot. Avoid brisk rubbing
(especially on dark fabrics). Normally, all removable
fabric parts can be washed in the washing machine
with a fine fabric detergent (no brightening agents) at
30 °C/85 °F (gentle cycle). Please check separate
care labels on the fabric parts.
Rain Cover
In rainy weather fit the rain cover over the entire
stroller/pram before it starts to rain.
Caution: The rain cover is not a toy! Never leave your
child unsupervised. For the best possible ventilation of
the stroller/pram we recommend using the rain cover
only for the duration of the rain shower.
Removing the hood cover
Both hood bars must be
removed from the cover be-
fore washing. (See illustra-
tion)
Loosen the screw using a
screw driver and remove the
press stud. Now pull the
cover bar out of the joint
and out of the hood cover.
After wash ing, reassemble
in reverse order.
When doing this, make sure that each cover bar is
pushed into both stitched guides. The front and back
bars must not be mixed up.
Unfolding the chassis
Pull the handle 1 up until the handle lock 2 clicks into
place.
WARNING: Ensure that all the locking de-
vices are engaged before use.
Folding the chassis
Simultaneously pull up both tensioning sleeves 1 on
both sides as far as they can go and at the same time
press the safety button on the right tensioning sleeve.
Then press the handle 2 down. Now you can addition-
ally make the storage dimensions smaller by folding
down the upper part of the handle.
Mounting and removing the wheels
Rear wheels:
To detach the rear wheel:
– Press the locking (7) and pull the wheel off the axle.
To attach push the wheel onto the axel.
Check that the wheel is proparly locked by pulling!
Front wheels:
To detach press the locking (10) and pull the steering
axle out. To attach, push the axel into place.
Check that the wheel is proparly locked by pulling!
11