Operation - PowerSmith PBL120J Manuel D'utilisation

ASSEMBLY AND ADJUSTMENTS
INSTALLING OR REMOVING THE BATTERY PACK
IMPORTANT!
The battery pack is not fully charged when it is purchased. Before using the product for the
first time, charge the battery pack. Make sure to read all safety precautions and follow the instructions in the Charging
Battery section.
Warning:
removal of the battery pack.
• To install the battery pack, slide the battery pack into the battery holder at the end of the product housing all the way
until it locks in place with a click, as shown in Fig 4. Lightly pull on the battery to ensure it is locked into place and
will not accidentally fall out of the product.
• To remove the battery pack, pull the battery pack away from the product while depressing the battery locking tab
(6-Fig 1).
APPLICATIONS
You may use this product for the purposes listed below.
•
Clearing leaves and yard debris from your lawn.
•
keeping decks, sidewalks and driveways free from leaves, debris and pine needles.
Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc.
Securely tighten all fasteners and caps and do not operate this product until all missing or damaged parts are replaced.
STARTING AND STOPPING THE BLOWER (FIG 5)
To Start the Blower, depress the trigger switch (2).
To Stop the Blower, release the trigger switch.
Speed Selector: Your blower is equipped with a speed selector (3). "I" is for the low air speed, "II" is for the high air
speed.
always be sure that the product is switched off before insertion or

OPERATION

English
2
9
FIG 4
3
FIG 5