Troubleshooting; Warranty - PowerSmith PBL120J Manuel D'utilisation

Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated wear
and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently, we do not recommended using this tool for extended work on these types of materials.
However, if you do work with any of these materials, it is extremely important to clean the tool using compressed air.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication.
STORING
•
Clean the blower thoroughly before storing.
•
Store the blower indoors, in a dry place that is inaccessible to children.
•
keep away from corrosive agents such as garden chemicals and deicing salts.
PROBLEM
Motor fails to start when
switch is depressed.
The air velocity decreases
significantly.
This product is warranted free from defects in material and workmanship for 3 years after date of purchase. This limited
warranty does not cover normal wear and tear or damage from neglect or accident. The original purchaser is covered
by this warranty and it is not transferable. Prior to returning your tool to store location of purchase, please call Toll-Free
Help Line for possible solutions.
THIS PRODUCT IS NOT WARRANTED IF USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
ACCESSORIES INCLUDED IN THIS KIT ARE NOT COVERED BY THE 3 YEAR WARRANTY.
BATTERY INCLUDED IS WARRANTED FOR ONE (1) YEAR AFTER DATE OF PURCHASE.
For questions about this or any other PowerSmith Product,
888-552-8665
Please call Toll-Free:
www.powersmithtools.com
Or visit our web site:
English
MAINTENANCE

TROUBLEShOOTINg

POSSIBLE CAUSE
Battery is not secure.
Battery is not charged.
Excessive wearing of motor fan.
The air inlet is blocked by debris.

WARRANTY

.
11
SOLUTION
To secure the battery pack, make sure
the latches on the top of the battery pack
snap into place.
Charge the battery pack according to the
instructions included with your model.
Call for PowerSmith technical service for
repair. Do not use the blower.
Remove the battery pack, clear the
debris.