Maintenance - PowerSmith PBL120J Manuel D'utilisation

CHARGING THE BATTERY (FIG 6)
NOTE:
Always Check that the power supply corresponds to the voltage on the ratings plate.
• Plug the power adaptor into a 120 Volt AC power source. The status light on the adaptor will illuminate green.
• Slide the battery all the way into the charger stand until it locks in place with a click, as shown in A-FIG 6. A red status
light indicates the battery is charging. The status light will turn to be green when the battery is fully charged.
• When the status light turns amber, it indicates the battery temperature is either too high or too low to be charged.
Wait the battery temperature back to room temperature before starting the charging.
• If the amber status light persists even when the battery temperature is in normal temperature range, the battery may
be damaged and will never be charged.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the tool, allow it to cool down to room temperature before charging. This will
extend the life of your batteries.
NOTE:
It takes approximately 60 minutes to charge up a completely discharged battery.
The battery pack has a power indicator showing how much battery power remains. Push the power indicator button to
check. Each green light indicates 25% of the battery power. Four green lights indicate the battery is 100% full.
USING THE BLOWER
•
To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a
pile.
•
To reduce sound levels, limit the number of pieces of equipment used at any one time.
•
Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces if water is
available.
•
Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and gardens.
•
Watch out for children, pets, open windows, or freshly washed cars, and blow debris safely away.
•
After using blowers or other equipment, clean up! Dispose of debris properly.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
Warning:
penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
OPERATION
A

MAINTENANCE

Do not at any time let brake fluids, gasoline, petroleum-based products,
English
battery
Charger Stand
10
POwer adaPtOr
StatuS Light
battery POwer
indiCatOr
POwer indiCatOr
buttOn
FIG 6