Publicité
Les langues disponibles
Les langues disponibles
USING YOUR SELECT ACCESS:
1) Ensure knob arrow is pointing to "LOCKED", if not, rotate knob anti-clockwise until it does.
2) Slide the reset button down and release it. (A)
3) Enter your code. Note - order of input does not matter. i.e. 1-2-3-4 = 4-3-2-1 = 3-1-4-2
4) Rotate the knob clockwise 180° until the arrow points to the "UNLOCKED" position.
5) Carefully pull door open.
6) Add Keys, FOBs, Access Cards, etc. that you would like to store in your Select Access.
7) Close door and rotate knob 180° anti-clockwise so the arrow points to the "LOCKED"
position.
8) Check to make sure your Select Access is fully locked by rotating the handle in a
clockwise orientation and verifying the door will not open.
INSTALLING YOUR SELECT ACCESS:
To install your Select Access, you will need the following tools:
• Power Drill
• 8mm Masonry Drill Bit
• Small Socket Driver
• 10mm Socket Head
• Lightweight Hammer
• Small Level
• Scissors
• Permanent Marker
IMPORTANT: It is recommended that your Select Access be mounted in a discreet location not visible
from general observation.
IMPORTANT: Do not mount your Select Access closer than 15cm from the corner of a masonry surface
and aim to minimize any gaps between back of your Select Access and the masonry mounting surface.
More information on
www.masterlock.eu
– Contact us :
mle@master-lock.fr
Publicité
