Mute Button; Gain Control; Phones Jack - YORKVILLE Traynor SB200H Instructions De Service

Passive
Power
On
Off
Power Switch and Lamp
The power lamp illuminates blue when ready to use, red for
standby, mute and protect,
Inputs and Clip LED
The 0dB input has been designed for bass guitars with
single-coil pickups and the -6dB input for for basses with
active or extremely 'hot' pickups.
User Tip: Do not use both inputs at the same time to
connect a second bassist or other musician.

Mute Button

The mute function disengages the preamp signal from all
outputs except for the Tuner jack. When enabled the power
light changes to the color red.

Gain Control

The Gain control sets the level of the signal before it's sent
to the tone controls.
Tone Controls
With a range of ±15db, these tone controls cover the
entire audio spectrum. The center position of each control
denotes a neutral or nominal setting.
Low Expander Control
The Low Expander shapes the tone by contouring the gain
of the mid frequencies while expanding the low frequency.
http://www.yorkville.com/manuals/
Input Gain Bass
Active
Mute
0 -6
Tuner
TRAYNOR SB106
Out
SmallBlock
106
SmallBlock
106 & 200H
To get the full Owner's Manual please visit our website at
Printed In CANADA
Printed In CANADA
QuickStart-SB106-SB200H-00-1v3 • YS#QSTART-SB • January 22, 2020
DOC-YS-Green-00-1v0PR02 • July 14, 2014
Low-Mid Hi-Mid Treble
Aux
Phones
In
EQ
Post
Pre
Line Out Line Out
AUX Input
This 1/8-inch input jack is used to connect an external sound
source from a digital audio player, a smart phone etc..

Phones Jack

Connect headphones here for practicing or recording.
Tuner Out Jack
Connect your instrument tuner here using a standard
shielded (e.g. guitar) cable.
Line Out EQ Switch
Engaged, the audio signal to the Line Out is routed through
the amp's tone controls (Post-EQ); disengaged, the signal
bypasses the EQ and is sent directly to the Line Out (Pre-EQ).
Line Out XLR and Lift/GND Button
The Line Out allows the user to connect the Small Block
preamp directly to a mixing console when performing
live or recording.
Speaker Out
The amp's minimum load is 4 ohms, you can connect a
total of one 4 ohm speaker cabinet or two 8 ohm cabinets in
parallel. When used, disables the internal speaker (SB106).
or, if you need a printed version call 905-837-8777
Low
Expander
SmallBlock
106
Min 4 ohms Min 4 ohms
GND
Lift
GND Spkr Out Spkr Out