YORKVILLE Traynor SB200H Instructions De Service page 13

M1590
V04
1_ BREAK THE CONNECTION OF XLR J4 SEE PICTURE.
2_ INSERT PUSHBUTTON KNOB ON SWITCH S1, S2 AND S3
BEFORE INSERTING INTO PCB. USE JIG AS SHOWN IN PICTURE
3_ MOUNT LD1 AND LD2 USING #8607 SPACER
AS SHOWN IN THE PICTURE.
4_ USE THE LED BENDING JIG TO BEND THE LEDS
TO THE CORRECT LENGTH.
5_BREAK PANEL BEFORE TEST AND REPAIR
6_ DO NOT FORGET TO ADD A 2-PIN HEADER
TO THE THERMISTOR HARNESS ASSEMBLY.
SEE BELOW.
INSERT
THERMISTOR HARNESS
PHOTO HERE
SEE LAYOUT DIAGRAM
PRODUCTION NOTES
INSERT
LED PHOTO
HERE
MAINS VOLTAGE INPUT SETTING (NA<->CE)
INSERT
ICE MODULE
PHOTO HERE.
SET JUMPER P200 TO "115V" FOR NA.
SET IT TO "230V" FOR CE.
Remove this
piece.
Break this
connection here.
YS#3425
INSERT
JIG PHOTO
HERE
YS#8636