Replacing The Viewpoint And Credit Available Switches; Removing The Steering Wheel; Replacing The Trigger Button; Replacing The Steering Potentiometer - NAMCO TOKYO WARS SD Manuel De L'opérateur

7-2 Replacing the Viewpoint and Credit Available Switches

1. Remove the four security screws (M6x25) and washers from the top of the
play panel and hinge the play panel forwards.
2. Remove the lamp/switch assembly by pulling it away from the switch body.
Replace the switch or lamp.
Note: When replacing the switch ensure that the wires are replaced to the
correct terminals

7-3 Removing the Steering Wheel

1. Carefully remove the round hub cover by gently levering out using a flat
blade screwdriver. ( Lever at different points around the hub cover to
remove evenly.)
2. Disconnect the connector. ( Take care not to strain the wires when
separating the connector.)
3. Remove the three button head screws and remove the steering wheel.

7-4 Replacing the Trigger Button

1. Remove the steering wheel.
2. Remove the four pozi head screws and remove the switch cover.
3. Replace the switch.

7-5 Replacing the Steering Potentiometer

1. Remove the four security screws (M6x25) and washers from the top of the
play panel and hinge the play panel forwards.
2. Remove the two pozi head screws and remove the potentiometer bracket
complete with potentiometer and gear wheel.
3. Loosen the grub screw and remove the potentiometer.
4. When refitting the potentiometer ensure that the locating lug engages in
the hole in the bracket and that the grub screw engages on the flat of the
potentiometer shaft.
Note: Ensure that the wires are reconnected to the correct terminals.
5. After the play panel has been refitted ensure that the game is re-
initialized (Refer to section 6-4)
Page 33
(Refer to section 7-3, above.)