Table des Matières
Publicité
(3) Installing hole when the Signal Receiving Unit is installed on the wall direct.
• Cut the thin-wall portion inside the bottom case (oblique section) by a knife or a nipper.
• Take out the connected remote control cord to the terminal brock through this space.
(4) Seal the Signal Receiving Unit cord lead-in hole with putty in order to prevent the possible entry of dew, water
droplets, cockroaches, other insects, etc.
• When installing on the switch box, seal the con-
nections between the switch box and wiring
pipe with putty.
When using the switch box
Wall
200
(5) Install the lower case on the switch box or directly on the wall.
(6) Install the cover
6
Test Run
CHECK
TEST RUN
˚C
AM
B
PM
AM
PM
NOT AVAILABLE
8
ON/OFF
45
MODE
CLOCK
FAN
6
7
VANE
STOP
START
3
HR.
MIN.
2
9
Remote control
cord
Wiring pipe
Locknut
Bushing
Switch box
Seal around here
with putty
A
1 Turn on the main power to the unit.
2 Set the Nrm/Set selector switch (on the back of the controller) to <<Set>>.
CHECK
TEST RUN
3 Press the
˚C
AM
PM
4 Press the MODE (
AM
PM
NOT AVAILABLE
ON/OFF
5 Press the MODE (
6 Press the FAN
Reset
After refiling batteries.
7 Press the VANE
Press the reset button.
Nrm
Set
8 Press the
9 After trial run is complete, set the Nrm/Set selector switch to <<Nrm>>.
NOTE: Point the remote controller toward the inside unit's receiver while
• When opening a hole using a drill for Signal Receiving Unit cord (or tak-
ing the cord out of the back of the Signal Receiving Unit), seal that hole
with putty.
• When routing the cord via the portion cut off from the upper case, equally
seal that portion with putty.
When installing directly on the wall
Seal around here
with putty
A the
and
begin to blink.
CHECK
TEST RUN
button.
MIN.
B
and current operation mode are displayed.
TEST RUN
whether air is blown out from the unit.
whether cool air is blown out from the unit.
button and check whether strong air is blown out from the
unit.
button and check whether the auto vane operates prop-
erly.
ON/OFF button to stop the trial run.
following steps 3 though 8.
Thin-wall protion
Remote control cord
Seal around here
with putty
Wooden screw (4 × 30)
) button to activate FAN
) button to activate COOL
Bottom case
mode, then check
mode, then check
4
Publicité
Table des Matières
