Black & Decker KA1000 Traduction Des Instructions D'origine page 35

Item Description
240 grit large detail sanding
sheet with two replacement
tips.
For a fi ne fi nish for large detail
sanding.
120 grit large detail sanding
sheet with two replacement
tips.
For a medium fi nish for large
detail sanding.
60 grit large detail sanding
sheet with two replacement
tips.
For a coarse fi nish for large detail
sanding.
High-gloss large detail
fi nish sheet (grey) with two
replacement tips.
For applying polish.
Cleaning sheet (red) for wood
or metal with two replacement
tips.
For cleaning or polishing tasks
on wood or metal.
120 grit detailed fi nger sanding
sheet.
For a medium fi nish for detailed
sanding.
120 grit profi le sanding sheet.
For a medium fi nish for profi le
sanding.
Assembly
Warning! Before assembly, make sure that the tool
is switched off and unplugged.
Fitting sanding sheets (fi g. A & B)
Detach the two additional diamond-shaped tips
♦
(10) from the sanding sheet (11).
Hold the tool with the sanding base facing
♦
upwards.
Place the sanding sheet (11) onto the sanding
♦
base, making sure that the holes in the sheet
line up with the holes in the base.
The diamond-shaped tip (10) can be reversed and
replaced when worn.
When the front part of the tip is worn, detach it
♦
from the sheet, reverse it and press it onto the
sanding base again.
When the whole tip is worn, remove it from the
♦
sanding base and fi t a new tip.
The polishing foam and pads (12) can be fi tted
♦
the same way as the sanding sheets.
For optimal dust collection, ensure the correct type
of sanding paper is used.
Tip of the sanding base (fi g. C)
When the sanding base tip (5) or tip holder (4) is
worn, it can be reversed or replaced. Spare parts
are available from your BLACK+DECKER dealer.
Remove the screw (8).
♦
Reverse or replace the worn part.
♦
Fit and tighten the screw.
♦
Finger attachment (fi g. D)
The fi nger attachment is used for fi ne detail
sanding.
Remove the screw (8).
♦
Remove the diamond-shaped tip holder (4)
♦
from the sanding base.
Fit the fi nger attachment (6) onto the sanding
♦
base.
Fit and tighten the screw.
♦
Fit the appropriate sanding sheet onto the
♦
fi nger attachment.
Profi le attachment (fi g. E)
The profi le attachment is used for contour sanding.
Remove the screw (8).
♦
Remove the diamond-shaped tip holder (4)
♦
from the sanding base.
Fit the profi le attachment (7) onto the sanding
♦
base.
Fit and tighten the screw.
♦
Fitting and removing a sanding profi le
(fi g. F1 & F2)
Choose the sanding profi le most suitable for
♦
your application.
Place one end of the sanding profi le (9) into
♦
the recess at the front end of the profi le holder
(7).
Push the other end of the sanding profi le until
♦
it clicks into place.
To remove the sanding profi le, push it forward
♦
and pull the rear end out of the profi le holder
(fi g. F2).
Fitting a sanding sheet onto a sanding profi le
(fi g. G)
Align the sanding sheet with the sanding profi le
♦
(9).
Press the sanding sheet onto the sanding
♦
profi le, making sure that the sanding sheet
follows the shape of the profi le.
ENGLISH
35