HoMedics FMS-360HJ Mode D'emploi Et Garantie page 4

INSTRUCTIONS FOR USE
To reduce the risk of electric shock, this unit is equipped with a polarized plug (one blade
wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
1. Plug into a 120-volt outlet.
2. It is highly recommended that you wear socks while using this foot massager. Do not use
the unit with shoes.
3. Place massager on the floor in front of your chair or seat and place feet in massager.
4. For your convenience, a wireless remote control is included. You can use the buttons on
Fig. 1
the remote control or the corresponding buttons on the massager with the touch of your
toe to activate and customize your massage. The buttons on the massager will illuminate
to confirm your selection.
5. To activate massage, press the power
will illuminate white to confirm your selection. The unit will start with both air and knead
at low intensity.
PROGRAM BUTTON
1. To toggle between the 3 auto massage programs, press the program
The button will illuminate white to initiate the first auto program.
2. To move to the next auto program, press the button again and the button will
illuminate green.
3. To move to the third auto program, press the button again and the button will
Fig. 2
illuminate blue.
4. To turn auto programs off, press the button for a forth time.
PROGRAM 1: Energize - variable vibration combined with the shiatsu and air to
energize and awaken the muscles
PROGRAM 2: Relax - a soothing program that combines kneading and air massage
in low intensity to comfort tired feet
PROGRAM 3: Recover - give your feet the needed recovery by combining high-intensity
vibration, kneading, and acupressure air massage. The program starts off from a
gentle to more intense massage
button. The power
4
button on the massager
button once.