Important; Adjustment - Ickle Bubba Mercury Mode D'emploi

15. Take the child out of the car seat as often as
possible in order to relieve pressure from their spine.
16. Please contact the distributor or manufacturer to
replace or supplement any components that may
have been missing or have been damaged.

IMPORTANT

KEEP FOR FUTURE REFERENCE

Adjustment:

1. To adjust the carry handle, press the buttons
on either side of the seat (1) shown in Picture 4,
while moving the handle into the desired position.
The carry handle can be locked in 3 positions:
A: Upright - to be used when in the vehicle or when
carrying the car seat by hand.
B: Locked - to be used to lock the car seat onto the
chassis.
C: Reclined - to be used when putting a child into
the car seat.
2. Loosen should er belts by pressing the Centre
function ad justment button and simultaneously pulling
both shoulder belts up (Picture 5).
3. To adjust the headrest and shoulder rest, open the
manual box und er the central belt guid e (Picture 6).
Pull the grey button (1) toward s you and
into the desired position (Picture 7). There are 6
positions, and the headrest must be the same height as
the childs shoulder (Picture 8).
19
V.01.21
Installing the car seat with ISOFIX base :
1. Loosen should er belts by pressing the Centre
function adjustment button and simultaneously pulling
both shoulder belts up (Picture 9).
2. Put the child into the seat and place shoulder
belt
shoulder belts are not twisted. Place both buckle
tongues together and lock them in place in belt buckle
with an audible "CLICK" (Picture 10). Pull carefully
on central adjustment belt in order to tighten shoulder
belts until they fit snugly (Picture 11).
3. Unfold the sun canopy by pulling on the plastic
cover. To fold up, push the sun canopy back to the
start position.
4. To install the Isofix Base, first pull up the grey button
(1) and push the support leg inwards to lengthen the
Isofix connectors at the rear of the base (Picture 12).
5.
ISOFIX anchors. When secured, the indicator color on the
ISOFIX connector will turn from orange to green (Picture
13/14).
6. Push the base towards the vehicle car seat to ensure it
is as close to the car seat's backrest as possible.
7. Push the buttons (1) on the support leg away from you
while moving the lower half of the support leg so that the
bottom of the leg touches the floor of the car foot well.
When in place, the indicator located at the bottom of the
support leg will turn from orange to green. (Picture 15/16)
move
8. Slide the car seat onto the base (Picture 17). When the
car seat is secured to the base, the indicator color turn
from orange to green (Picture 18)
directly over the child's shoulders, ensuring the
Firmly push the Isofix connectors onto the cars
V.01.21
20