Ickle Bubba Mercury Mode D'emploi page 10

Notice：
1. This is an "i-Size" Child Restraint System. It is approved
to Regulation No.129, for use in "i-Size compatible"
vehicle seating positions
manufacturers in the vehicle users' manual.
2. If in d oubt, consult either the chil d
manufacturer or the retailer.
Warning：
1. Any straps holding the restraint to the vehicle
must be tight, any
contact with the
restraining the child must be adjusted to the child's
body, and the straps should not be twisted;
2. The rigid items
restraint must be located and installed so that they are
not liable to become trapped by a movable seat or in a
door of the vehicle during everyday use.
3. Do not use in seating positions where an active
frontal airbag is installed.
4. The device must be changed when it has been subject
to violent stresses in an accident.
17
as ind icated by
restraint
support-leg must be
vehicle floor, any
and plastic parts of a
V.01.21
5.
to the device without the approval of the Type Approval
Authority, and a danger not to follow the installation
vehicle
instructions provided by the child restraint manufacturer.
6.
system unattended.
7.
in the event of a collision must be properly secured.
8 . The child restraint shall not be used without the cover.
9. The seat cover should not be replaced with any other
cover than the one recommend ed by the manufacturer.
The cover is
performance.
in
10.Please check your vehicle manufacturer's handbook
straps
before use.
11. The instruction manual must be kept in the location
child
shown in Picture 2 while the infant car seat is in use.
12. It is d angerous to use the car seat on an elevated
surface, e.g. a table.
13. This car seat is not intend ed for prolonged periods
of sleeping.
It is dangerous to make any alterations or additions
Children should not be left in the child restraint
Any luggage or other objects liable to cause injuries
an integral
V.01.21
part of the restraint
18