Additional Safety And Working Instructions; Work Instructions - Güde 58499 Traduction Du Mode D'emploi D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
ENGLISH
22
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.  This
will ensure that the safety of the power tool is maintai-
ned.
Additional Safety and Working
Instructions
Do not use the device near flammable liquids or gases. Risk
of fire and explosion in case of short circuit.
Battery
Never use the charger in moist or wet conditions. Suitable
for indoor areas only.
Make sure the system voltage corresponds to the charger
type plate details. There is a risk of electric shock.
Cable connections to be separated by pulling the plug only.
Pulling the cable could damage both the cable and plug. As
a result, electric safety would no longer be guaranteed.
Never use the charger when the cable, plug or the machine
is damaged by external influences. In case damage let
repaired in authorized workshop
The Güde charger to be used only to charge the battery. There
can be malfunction or fire if different chargers are used.
Vapours may leak out in case of unauthorised use or when
using a damaged accumulator. Bring fresh air and seek me-
dical advice if experiencing difficulties. Vapours may irritate
the respiratory system.
Risk of fire! Risk of explosion!
Never use damaged, defective or deformed accu-
mulators. Never open or damage the accumulator
or let it fall on the ground.
Never charge the battery in an environment with
acids and easily flammable materials.
Protect the battery against heat and fire.
Battery to be used at the ambient temperatures
between 10°C and +40°C only.
Never put the battery on heaters and do not
expose it to strong sunlight for a long time.
After being subject to heavy load, let the battery
cool down first.
Short circuit - do not bridge the accumulator
contacts with metal parts.
The accumulator must be packaged (plastic bag,
box) or accumulator contacts must be sealed up
for accumulator disposal, transport or storage.

Work instructions

Accumulators are supplied partially charged and must
therefore be fully charged before being used for the first
time.
• Charge the accumulator when the appliance is running
slowly or stops.
• A li-ion battery may be charged at any time without any
shortening of its life. Charging process interruption will

Publicité

Table des Matières
loading

Table des Matières