Assembling The Filter - BWT RTM HF S-500 Notice D'installation Et Conseils D'utilisation

2.

ASSEMBLING THE FILTER

1
2
3
4
5
CONSTRUCTION & RÉNOVATION
Remove the diffuser and swing the collector to the side.
Check that the drain valve is closed.
Fill the pump with water until the water level is 5 cm above the
laterals.
Pour the sand (granulometry 0.6/1.25) in carefully to avoid
damaging the laterals.
Put the diffuser back in position.
Fit the o-rings into the grooves on the bulkhead fittings.
Assemble the air bleed valve on the lid.
2021/01 - Indice de révision : I - Code : 26680
17/36