Hendi H90 Mode D'emploi page 5

Grounding installation
This appliance is classified as protection class I and
must be connected to a protective ground. Ground-
ing reduces the risk of electric shock by providing an
escape wire for the electric current. This appliance
Preparation before using for the first time
• Remove all protective packaging and wrapping.
Make sure no packaging debris remain on or in-
side the appliance.
• Check for completeness (4 trays and 1 tray han-
dle included) and any transport damage. In case
of damages or incomplete delivery, please contact
supplier (See --- > Warranty page).
• Keep the packaging for storing your appliance
when not in use for an extended period of time.
• Place all the trays & the tray handle inside.
• Connect the power plug to a suitable electrical
wall outlet.
• Select the following settings consecutively.
Control
Temp control
Timer control
Electric diagram
Setting
300°C
10 minutes
is equipped with a cord having a grounding wire with
a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
• The Temp control indicator
dicator and the internal light of the appliance
are all lights up.
Note: Due to the manufacturing residues, the ap-
pliance may emit a slight odor. This is normal and
does not indicate and defect or hazard. Make sure
the appliance is well ventilated.
• When the set time ends, the appliance tempera-
ture and timer indicators goes off.
• Allow the appliance to cool down completely and
clean it afterwards (See ---> Cleaning and main-
tenance).
, Timer control in-
EN
5