*You can change the SUBTITLE LANGUAGE among: English, German, Spanish, French,
Italian and Portuguese and OFF.
*You can change the MENU LANGUAGE among: English, German, Spanish, French, Italian
and Portuguese.
3) AUDIO SETUP
When you open the AUDIO menu, you will see the following picture:
* KEY: Change the tone within a certain range.
4) VIDEO SETUP
When you open the VIDEO menu, you will see the following picture:
You can use the
the brightness, contrast, hue, saturation and sharpness.
5) DIGITAL SETUP
When you open the DIGITAL menu, you will see the following picture:
*OP MODE: to set the operating modes for Dolby Digital decoder, there are LINE OUT and RF
REMOD to be selected.
* DYNAMIC RANGE: you can adjust the dynamic range between 1/8, 2/8. 3/8, 1/2, 5/8, 3/4,
FULL.
Choose this setting to adjust the line out ratio and get different effect. If adjusting to FULL,
the audio signal peak value will be the minimum, while adjusting to OFF, maximum.
*DUAL MONO: there are STEREO, MONO L, MONO R and MIX MONO to be selected.
/
buttons on the remote control or on the unit to adjust the value of
20