Mesa Living 804.078 Manuel D'instructions page 18

Maintenance
Cleaning
Caution:
Before cleaning please turn off the air
conditioner and pull out the plug.
Cleaning surface

Clean the surface of the air conditioner with a
duster or a semi-wet soft cloth.

Do not use chemical reagents, such as benzene,
alcohol and gasoline, etc. Otherwise the
surface of the air conditioner will be damaged
or even the whole air conditioner will be
damaged.
Cleaning of the filters

If the filters are blocked by dust, air circulation will be impeded and reduce efficiency of the air
conditioner.

If the air conditioner is used for long time, then is cleaning filters once per two weeks recommended.
1) Pull out the filters in the direction as shown in Fig. 6.
2) Put the filters in warm water with neutral detergent (about 40℃) and clean up. Dry the filters in a
shaded place after cleaning
3) Install the filters to the original position in the direction as shown in Fig. 6.
4) Process of taking out the filters: first take out filter 1 and then filter 2; process of installing strainers:
first install filter 2 and then filter 1.
Storage
When the air conditioner will not be used during the season or for a long time, these maintenance measures
should be taken:

Remove the condensed water (water can be poured out by slowly leaning the body backward during
drainage). Select the FAN mode and then press SPEED for 5 seconds till the fan works, keep this mode
for 2 to 3 hours. This method dries the inside of the body and prevent mildew.

Turn off the air conditioner and pull out power plug.

Wind up, fasten and put away power line.

Remove exhaust pipe and keep properly.

Set the air conditioner into plastic bag and put it in a dry place.

Take out the batteries of remote control and keep properly.
List of included items
1 x Exhaust hose outer diameter and extended length
φ15cm 28cm~150cm
1 x Oblate joint
1 x Round joint
1 x Adjustable window seal plate – 1 length
90cm~130cm
1 x Screw (10mm)
Filter Unit 2
Screw
Round
joint
Filter Unit 1
Fig. 6
Oblate
Hose
joint
Window seal plate