Operating Methods - Mesa Living 804.078 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating methods

Timer setting
1.
Setting timer ON
When the air conditioner is in standby state, press the button TIMER, the timer LED lamp is on. Meanwhile the
display will flicker "
Within 3 hours , the time changes 0.5h by pressing UP or DOWN. Between 3 and 24 hours, the time changes 1h
by pressing UP or DOWN. During setting of timer, the operating modes after start can be selected, if COOL
mode is selected, the set temperature can be adjusted simultaneously. After the set time expires, the air
conditioner starts automatically and runs in the selected operating mode.
2.
Setting timer OFF
When the air conditioner is running, press this button TIMER, the timer LED lamp is on. Meanwhile the display
will flicker "
" for 5 times. At this moment press UP or DOWN to adjust time from 0.5h to 24h. Within 3
hours , the time changes 0.5h by pressing UP or DOWN. Between 3 and 24 hours, the time changes 1h by
pressing UP or DOWN. When the set time expires, the air conditioner turns off automatically.
3.
Change of the set time
If you want to change the time during the running TIMER mode, you can press the button TIMER one time. The
display will flicker the remaining time, then press UP or DOWN to increase or decrease the time of the original
time. If you press TIMER again during flicker, the set time will be cancelled..
Operation
1.
COOLING
In ON or TIMER ON state press MODE to select COOL mode. The corresponding LED-light on the panel
is on.
Press UP or DOWN to set the desired temperature (between 18 and 30℃ (64-86℉)).
When pressing UP or DOWN once, temperature will go up or down by 1℃ or 1℉ every time.
Press SPEED to set the desired ventilator speed and press LOW and HIGH to change the speed.
After selecting COOL mode, press SLEEP on the remote control (or press UP and TIMER on the panel
simultaneously) to enter SLEEP mode. Both fans are set at LOW speed. When the set time expires, the
air conditioner turns off automatically.
2.
DRY mode
When the air conditioner is running, press MODE to select DRY mode. The corresponding LED-light on
the panel is on.
Temperature and speed are not adjustable.
3.
FAN mode
Press MODE to select FAN mode. The corresponding LED-light on the panel is on.
Press SPEED to select the desired speed and with LOW and HIGH the speed can be changed.
Temperature is not adjustable.
Cautions:
When full water indicator LED-light is on, the air conditioner stops working, you should drain water in
time. After draining the air conditioner will start automatically.
Please close the curtains, if the room faces the sun directly.
" for 5 times. At this moment press UP or DOWN to adjust time from 0.5h to 24h.

Publicité

Table des Matières
loading

Table des Matières