Corrective Action - ACCO Brands GBC Ultima 35 Manuel D'installation Et D'utilisation

SYMPTON POSSIBLE CAUSE
Pressing the Laminator is not
Standby Power connected to electrical
button does not supply.
turn the machine
ON The power cord might not
be inserted all the way
into outlet.
Machine is ON but Feed Table switch is not
will not run fully closed to activate
safety switch
Machine rollers Media is too thick
stop/stall while
laminating Look for film wrap around
rollers
Film Doesn't Stick Machine not hot enough
to Media
Running to fast
Wrong Film Setting
Adhesives will not stick to
select Inks/Toners/Toner
Oils/Coatings
Laminated items Tension on top or bottom
are wrinkled supply roll is too loose.
Film holder lever is not
closed.
Film or Media Machine not hot enough
appears cloudy,
milky or silvering Running to fast
(very small dots
typically seen in Wrong Film Setting
dark areas)
Adhesives will not stick to
select Inks/Toners/Toner
Oils/Coatings
Machine can also be too
hot
Long Ripples Film is too hot when
appear on the Film exiting the pull rollers on
and/or Media the back of the machine.
TROUBLE SHOOTING

CORRECTIVE ACTION

Fully insert plug into outlet
Make sure outlet has power
Ensure the Heat Shield and Feed table are fully closed.
If possible, use thinner media.
If film is wrapped around roller use procedure outlined in Clearing a
Jam.
Ensure ready light is on
Try slower speed setting
Confirm proper film thickness selected
If possible print document on another printer
Close lever completely
Ensure ready light is on
Try slower speed setting
Confirm proper film thickness selected
If possible print document on another printer
.
Try faster speed.
Slow down the laminator
Common on longer lamination runs. Try shorter runs or stop to let cool
when present
16