Uniteck UNIFIX 800 EGF Mode D'emploi page 19

EN
Dear customer, thank you for purchasing one of our Uniteck products. Please read all the instructions
carefully and thoroughly before using the product.
DESCRIPTION
The Unifix 800 EGF Unifix brackets have been specially designed to fix your Unisun photovoltaic panels or
equivalent (see compatible panels part)
Easy to install, Unifix 800 EGF can be fixed on a horizontal or flat surface (e.g. wall, concrete floor, wood
frame) or can be weighted to the ground (e.g. turf)
They can be :
- fixed on a concrete floor thanks to its 8 m8-studs (not included)
- weighted using a ballast box for unifix 800 egf (option).
- weighted using the brackets for concrete slabs (option).
With their galvanized steel structure and corrosion-resistant stainless-steel screws, they are perfectly suited
for outdoor use.
Equipped with a multi-position tilting system, Unifix brackets enable an optimization of your panel's
performance depending on the chosen orientation :
- only unifix 800 egf : the adjustment angle is from 10 to 60 degrees.
- with ballast box option : the adjustment angle is from 30 to 60 degrees.
- with brackets for concrete slabs option : the adjustment angle is from 20 to 60 degrees
Thanks to its innovative design, UNIFIX 800 EGF brackets can be used to create a multi solar panels
installation.
COMPATIBLE PANELS
With the design based on the use of Oblong drilling,
Unifix allows the fixing of different panels of the market.
Unifix 800 EGF accepts 1, 2 or 3 panels
depending on the models, with the spacing
and dimensions of panels indicated below:
- width from 808 to 1200 mm
- length from 1200 o 2300 mm
18
M8 screw
1450mm
90mm
min
Bottom part of UNIFIX 800 EGF mount
www.uniteck.fr
808 to 1200mm
max
1200mm
to
2300mm