Weidmüller WAVE Série Notice D'utilisation page 12

1 General instructions
The WAVESERIES signal conditioner DC/DC CCC LP without
additional voltage supply should only be installed by qualified staff
and should only be powered up following professional installation.
2 Application
The WAVESERIES signal conditioner DC/DC CCC LP without
additional voltage supply are suitable for connection to 2-wire
sensors. The signal is galvanically isolated and equally emitted as
a 2-wire signal. The voltage supply for input/output is generated
from the input-circuit.
3 Mounting and dismounting
Warning!! Mounting and dismounting may only be carried out
when the power supply has be disconnected. Failure
to observe will lead to considerable damage!
12