Gardebruk Deuba ASX900 Mode D'emploi page 37

WARNING: Dull or improperly sharpened chain can cause excessive motor speed
during cutting which may result in severe motor damage.
WARNING: Improper chain sharpening increases the potential of kickback.
Failure to replace or repair damaged chain can cause serious injury.
Storing the product
Clean all foreign material from the product. Store the unit indoors in a dry and well-
ventilated area that is inaccessible to children. Keep away from corrosive agents such
as garden chemicals and de-icing salts. Always place the scabbard on the saw bar when
transporting or storing the pole chain saw. The scabbard is a snug fit and must be
attached very carefully due to the sharp teeth on the saw chain. This is best done by
grasping the scabbard at one end, in the center portion of the scabbard, and carefully
sliding it over the chain as shown. Use caution to avoid the sharp teeth of the chain.
NOTE: The saw chain is very sharp. Always wear protective gloves when handling the
chain.
PROBLEM
Bar and chain running hot
and smoking.
Motor runs, but chain is
not rotating.
Troubleshooting
POSSIBLE CAUSE
-Check chain tension for
over tightened condition
-Bar lube reservoir empty
-Chain tension too tight.
Check guide bar and chain
assembly.
-Check guide bar and chain
for damage.
REMEDY
-Tension chain. Refer to
Chain Tension earlier in
this manual.
-Check bar lube reservoir.
Disconnect the device from
the power supply!
-Retention chain. Refer to
Chain Tension earlier in
this manual.
-Refer to Replacing the Bar
and Chain earlier in this
manual.
-Inspect guide bar and
chain
www.DeubaXXL.de
37