Laser Safety - General International DP2006 Manuel D'installation Et D'utilisation

NOTE: The use of an adaptor plug is illegal in some areas, including
Canada. Check your local codes. If you have any doubts or if the
supplied plug does not correspond to your electrical outlet, consult a
qualified electrician before proceeding.
ExTENSION CORDS
If you find it necessary to use an extension cord with your machine, use
only 3-wire extension cords that have 3-prong grounding plug and a
matching 3-pole receptacle that accepts the tool's plug. repair or replace a
damaged extension cord or plug immediately.
Make sure the cord rating is suitable for the amperage listed on the motor
i.D. plate. an undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. the accompanying chart shows the correct
size extension cord to be used based on cord length and motor i.D. plate
amp rating.
Feet
Amp Rating 25
3-10 amp 18 ga.
10.1 - 12 amp 16 ga.
12.1 - 16 amp 14 ga.
wARNING! Do not allow familiarity with your tool to make your
careless. Remember that a careless fraction of a second is sufficient to
inflict severe injury.
IMPORTANT: The warnings, cautions and instructions detailed in this
manual cannot cover all possible conditions and situations that occur. It
must be understood by the operator that common sense and caution are
factors that cannot be built into this product, but must be supplied by the
operator.

LASER SAFETY

this tool is equipped with a patented precision cross-pattern laser
alignment and centering guide.
1. DO NOT STARE DIRECTLY AT THE LASER BEAM.
DANGER! Eye damage may occur if you deliberately stare into the
beam.
2. THE LASER LIgHT BEAM
used in this system is class ii with maximum 1 mW and 650 nm
wavelengths. aVoiD Direct eYe eXPosure.
3. THE LASER MUST BE USED AND MAINTAINED IN ACCORDANCE
WITH THE MANUFACTURER'S INSTRUCTIONS:
• Never aim the beam at any person or an object other than the
workpiece.
• Do not project the laser beam into the eyes of others.
• always ensure the laser beam is aimed at a workpiece without
reflective surfaces as the laser beam could be reflected into your
eyes or the eyes of others.
10
Total Extension Cord Length
Meters Feet Meters
8 50 15
16 ga.
16 ga.
12 ga.
use only uL or csa approved extension cords
Feet Meters Feet
100 30 125
14 ga.
14 ga.
not recommended
Meters
40
14 ga.
14 ga.