Safety Instruction - AOSmith MVI 103 Notice D'installation Et D'utilisation

MVI pompstation / MVI pump station / station de pompage MVI
2 Safety instructions
The installation and commissioning of the high capacity pump station as well as the
connection of electrical components requires technical knowledge commensurate with a
recognized vocational qualification as a fitter for plumbing, heating and air conditioning
technology, or a profession requiring a comparable level of knowledge. The following must
be observed during installation and commissioning:
•
Relevant local and national prescriptions
•
Accident prevention regulations of the professional association
•
Instructions and safety instructions mentioned in these instructions
Attention: Risk of burns and scalding!
The valves and fittings can heat to temperatures of more than 100 °C due to
the solar fluid. Therefore, do not clean or fill the installation with the
collector's heated (intense sunshine).
Observe that hot solar fluid can leak from the safety valves in case of too
high system pressure!
Attention: Material damage due to high temperatures!
Install the valves and fitting group at a sufficient distance to the collector
field, since the solar fluid may be very hot near the collector.
It may be necessary to install an intermediate tank in order to protect the
expansion vessel.
Attention: Material damage due to mineral oils!
It is imperative to avoid that the EPDM sealing elements of the station get in
contact with substances containing mineral oils. Mineral oil products cause
lasting damage to the material, whereby its sealant properties are lost.
If necessary, ask the manufacturer whether the solar fluid, fats or installation
aids contain mineral oils.
We do not assume liability nor provide warranty for damage to property
resulting from sealants damaged in this way.
53