stayer E150C Instructions D'emploi page 12

gb
5_INITIAL OPERATION
Observe correct mains voltage: The voltage ofthe
power source must agree with the voltagespecified on
the name plate of the machine.Equipment marked with
230 V can also be connected to 220 V.
Switching on: On/Off switch 7 to position I.
Switching off: On/Off switch 7 to position O.
Test run: Before using for the first time, run machine
for at least 5 minutes without load.Dress a new
grinding wheel with a dressing stone.
6_GRINDING WHEEL REPLACEMENT
Pull the plug from the socket.
Loosen the 3 screws of the protective cover 1and
remove the protective cover. Unscrew the clamping
nut 2 while holding the grinder spindle 5 with an
open ended spanner on the spanner surfaces of the
respective side.
Caution:
lefthandedthreads on the left side!
Remove clamping flange 3 and grinding wheel.
The mounting of the new grinding wheel is performed
in the reverse order. Press the protectivecover 1 on
firmly and tighten the screws.
Testing new grinding wheels
Use only original Stayer grinding wheels!
Damage to the original packaging could indicate
defects. Check before mounting that the grinding
wheel is free of damage.
The maximum allowable RPM of the grindingwheels
used must at least correspond to the maximum no-
load RPM of the machine.
Test run new grinding wheels at least 5 min-
utes and then dress with the dressing stone
(accessory).
Dress used, out of round grinding wheelswith the
dressing stone (accessory) beforecontinuing to
use.
7_OPERATING INSTRUCTIONS
Lay the workpiece to be ground on the toolrest 11 and
press lightly against the grinding wheel. To achieve
optimal grinding results, movethe workpiece lightly
back and forth. This also contributes to uniform wear
of the grinding wheel.
Cool the workpiece in water from time to time. For
grinding hard metal workpieces, use siliconcarbide
C grinding wheels (accessory). Protect the grinding
tool from impact, shock andgrease. Do not work with
materials containing asbestos.
Grinder spindle 5
8_MAINTENANCE AND CLEANING
Before any work on the machine itself, pull the mains
plug.
Always keep the machine clean.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repairshould
be carried out by an aftersales service centre for
Stayer power tools.
In all correspondence and spare parts orders,please
always include order number given on the name plate
of the machine.
WARNING! This appliance must be earthed.
9_REPAIR SERVICE
The technical service will provide you advice regarding
questions you may have on the repair and maintenan-
ce of your product as well as on spare parts. You may
also obtain exploded views and information on spare
parts on the internet under: info@grupostayer.com
has
Our team of technical advisors will be glad to guide
ou regarding acquisition, application and adjustment
of products and accessories.
10_GUARANTEE
Guarantee card
Included in the documentation that accompanies this
equipment, you should find the warranty card. You
should fill out the card completely and return to vendor
with a copy of purchasing receipt or invoice and you
should receive a receipt.
Note: If you cannot find the warranty card within
the documentation, you must ask for it through
your supplier.
The warranty is limited only to manufacturing defects
and expire if pieces have been removed o
11_DISPOSAL
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According the European Guideline 2002/96/
EC for Waste Electrical and Electronic
Equipment and its implementation into
national right, power tools that are no longer usable
must be collected separately and disposed of in an
environmentally correct manner.
- 12 -