Bimar FGD-12C Notice D'instructions page 12

•
Battery life depends on various environmental, storage and usage factors.
• If the charger is not in use, unplug it from the power outlet.
• Do not touch the charger with wet hands or feet.
• Do not pull on the power cord to disconnect the plug from the charger's power socket.
• Do not pull on the charger cable to move the fan.
• Do not charge the battery and use the fan if the battery starts to emit odours, overheats
or starts to leak. Do not touch any leaking substances or breathe in the fumes from them.
Seek immediate medical attention if you are exposed to any substance emitted from the
battery. The manufacturer cannot be held responsible for any damage resulting from
improper use (such as tampering with the battery), incorrect and irresponsible use and/or
repairs carried out by unqualified persons.
• When charging the battery, make sure that it does not come into contact with water or
other liquids. If it inadvertently gets wet or is immersed in liquid, first deactivate the power
socket by turning off the switch on the electrical panel, and only then remove the plug
from the power socket. Carefully dry both the plug and the socket, and only then turn on
the power at the socket. Insert the plug into the power outlet again, and you can then use
the appliance. In case of doubt, contact professionally qualified personnel.
INSTALLATION
• After removing the packing materials, check the integrity of the heater; if you are
unsure, do not use it and ask for qualified professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger. Attention: any stickers or advertising
material applied to the grid removed before using the appliance. The manufacturer
declines all responsibility in case this is not safe working practices will be respected.
• Before connecting the appliance, check that the voltage shown on the data plate of
the adapter matches that of your electricity. In the event of incompatibility between
the electric outlet and the plug of the appliance, have the outlet replaced with
another more suitable type by professionally qualified personnel, who will make sure
that the section of the wires of the adapter is appropriate for the absorbed power of
the appliance. In general, the use of adapters or extension cords is not
recommended; if their use is indispensable, they must conform to existing safety
standards and their current capacity (amperes) must not be less that the maximum
of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case
of emergency.
• Do not place the fan on a shelf and/or near sinks or other container of liquids
(minimum distance of 2 meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could
obstruct the air intake grille; make sure that the front is free of unstable materials
(dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and
not twisted or wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined
plane (the appliance could upset).
• Do not place the appliance near an open flame, cooking or other heating appliance.
• This appliance must only be used with the adapter supplied.
12