Bimar FES-45II Notice D'instructions page 12

repairs carried out by unauthorised personnel may be
dangerous and nullify the guarantee.
 Ensure that the fan is switched off from the supply mains
before removing the guard.
INSTALLATION
 After removing the packing materials, check the integrity of the appliance; if
you are unsure, do not use it and ask for qualified professional help. The
packing materials (plastic bags, polystyrene, nails, etc.) must be kept out the
reach of children because they are potential sources of danger. Note: any
stickers or advertising material applied to the grille must be removed before
using the appliance.
 Before connecting the appliance, check that the voltage shown on the data
plate matches that of your electricity, and that the electric plug is grounded. In
the event of incompatibility between the plug point and the plug of the
appliance, have the plug replaced with q suitable one by professionally
qualified personnel, who will make sure that the section of the wires of the
outlet is suitable for the power drawn by the appliance. In general, the use of
adapters or extension cords is not recommended; if their use is necessary, they
must conform to existing safety standards and their current capacity (amperes)
must not be less than the maximum of the appliance.
 Before each use, check that the equipment is in good condition, that the power
cord is not damaged: if in doubt consult a qualified professional.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 Keep the appliance away from:
heat sources (e.g. open flame, gas stove, etc.)
-
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the
-
appliance or it falling in (minimum distance of 2 meters)
fabrics (curtains, etc.) or floating materials that could obstruct the air
-
intake grille; make sure that the front is free of floating materials (dust,
etc.).
 The appliance must not be used in dusty environments or in the presence of
floating materials or used in a room where there is a fire risk.
 Stand the appliance on a smooth, horizontal surface or table; do not place it on
a inclined surface (the appliance could fall over).
12/36