Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Manual & Parts List
ASSEMBLY (CONTINUED)
Head Rotation
Locking Handle
Figure 10 - Secure Head Assembly
MOUNT DRILL CHUCK
Refer to Figures 11 and 12.
• Be sure spindle taper and chuck taper are clean and dry.
• Insert chuck key into chuck and turn key counterclockwise until
the chuck jaws are completely inside chuck.
Chuck Taper
Chuck Jaws
Figure 11 – Clean Chuck Taper and Retract the Chuck Jaws
• Push chuck over spindle taper and twist chuck slightly to
release air trapped in taper.
• Use a hammer to carefully tap chuck securely onto the spindle.
Spindle Taper
Head Angle
Locking Handle
Figure 12 - Secure Chuck onto Spindle
MOUNT QUILL FEED HANDLES
Refer to Figure 13.
• Thread the three quill feed handles into the threaded holes on
the pinion hub.
Chuck Key
Quill Feed Handle
Figure 13 - Install Quill Feed Handles
ADJUST V-BELT TENSION
Refer to Figure 14, page 7.
• Open the pulley cover and loosen both motor lock knobs (one
on each side of the head).
• Push motor back to apply tension to v-belt.
• Correct tension is obtained when the v-belt can be flexed
approximately
6
EN
Hammer
Pinion Hub
" at belt midpoint using finger pressure.
3
/
8
Publicité
Table des Matières
