LEMAN PRC016 Manuel D'utilisation page 26

Operating Manual & Parts List
ASSEMBLY (CONTINUED)
Table Arm
Bracket Assembly
Figure 6 – Position Table Arm Bracket Assembly on Column
•
Slide retaining ring over column with beveled edge down.
Position ring against top of rack so that rack is in beveled edge
of ring. Secure ring with set screw.
• Rotate table assembly around column. Adjust ring as necessary
to prevent binding of rack.
• Attach crank handle onto worm gear shaft. Secure handle with
set screw, tighten screw on flat of worm gear shaft.
• Insert table bracket locking handle into bracket and tighten to
secure bracket.
Rack
Crank
Handle
Figure 7 – Attach Retaining Ring, Crank Handle and
Locking Handle
• Insert the extension arm into the table arm bracket assembly.
Rack
• Insert the table into the extension arm.
• Insert locking handles into the table arm bracket assembly and
Worm Gear
Figure 8 – Attach Extension Arm and Table
MOUNT HEAD ASSEMBLY
Refer to Figures 9 and 10.
WARNING:
heavy. Two people are required to mount the drill press head
Retaining Ring
assembly onto the column.
• Place locking shoe into the cavity in the ram bracket.
WARNING:
the locking shoe is in place. The head assembly cannot be properly
secured to the column without locking shoe.
Ram Bracket
Locking
Handle
Figure 9 – Place Locking Shoe Into the Cavity in Ram Bracket
• Slide drill press head assembly onto top of column.
• Position head so that it is centered over base.
• Secure head assembly into position by tightening the locking
5
EN
NOTE: The table can be installed directly to the table arm
bracket assembly.
extension arm. Tighten to secure table and extension arm.
Table
Locking Handle
Although compact, the drill press head assembly is
Do not install the head assembly onto column unless
Table
Cavity
Locking Shoe
handles (see Figure 10, page 6)
Extension Arm
Table Arm
Bracket
Assembly