Introduction; Operating Elements - Rohde TC 304 Guide D'installation, De Programmation Et D'utilisation

Introduction

The control unit TC 304 is the leader of its class, due to the high-end technology used
in this outstanding controller series .
Read these instructions to familiarise yourself with all features of the TC 304 . Read
through them carefully and pay attention to the safety instructions of the kiln manu-
facturer . Please make sure that the controller is installed at an adequate distance from
the kiln . It should never be exposed to heat generated by exhaust fumes or radiation
emitted by the kiln .
Operation elements
1 Actual value display
2 Display of units / values
3 Checking / Entering delay time
4 Checking / Entering 1 . warming-up time
5 Checking / Entering dwell time point
6 Checking / Entering 2 . warming-up time
7 Checking / Entering final temperature
8 Checking / Entering dwell time at final temperature
9 Checking / Entering cooling-down temperature
10 Display for program end
11 Key for selecting programs 1– 5
12 Key „go to previous"
13 Key to „Start / Stop" program
14 Change current value +
15 key „go to next"
16 Change current value -
1
7
6
5
4
3
12
13
2
8
9
10
11
14
15
16
13