Philips AJL750 Instructions De Montage

Wall Mounting Instructions
Instrucciones de montaje en pared
Instructions relatives à la fixation murale
Profondeur recommandée pour le
meuble afin de permettre les con-
nexions à l'arrière 2.5"
DC
Debe haber al menos 2.5" distancia
entre la unidad y la pared.2.5"
Mount it
Ask a friend to help out. An extra hand to hold the unit makes mounting easier
and quicker.
A
•
•
•
•
•
Recommended depth of cabinet at
the rear to allow for connections
2.5"
B
Use 1/4"
Using the spacers
drill
On the spacers, there are 4 pairs of notch length
options. Depending on the thickness of you cabi-
net bottom (with/ without an overhang), these
notch lengths correspond to the 4 notch height in
the space holders, and allow you to adjust to the
best height to help you mount the unit.
•
•
•
C
•
Cut the template to fit inside the cabinet.
A
Template
Align the template border marked "FRONT "
along the front edge of your cabinet.
Use adhesive tape to fix the template.
Drill 1/4 inch holes, as marked X on the tem-
plate.
Remove the template when you finish drilling.
Tip
– Clean the bottom of the cabinet surface and also empty your cabinet
before mounting.
– Place the unit in a clean, safe place when drilling to avoid wood
shavings dropping into the ventilation slots.
– Use a nail to start each drill hole.
– Drill from the bottom upwards if you do not have enough room inside
the cabinet.
– Hold your drill firmly at 90 o with the cabinet bottom and drill holes at
low speed.
– Clear wood shavings.
B
Spacer
L (Low)
L••H (4 heights)
Arrow
Measure the height of the cabinet bottom
and/overhang.
Turn the spacer counterclockwise to determine
which of the 4 heights is most suitable: L ow •
• H igh. Align to the arrow indication.
Insert the spacers accordingly.
C
Manually fasten the 4 screws down into
the spacer holder holes to mount your
set. Start screwing at opposite corners of
the unit for better support.
Tip
To prevent damage to your set, do not use an
electric drill to secure screws when mounting!
– If the overhang is more than 1 1/4 inch, use longer screws
(not included).