Allied Vision GiGe VISION Mako G Guide De Démarrage Rapide page 10

Overview of installation
Complete the steps listed below to successfully install your Mako G camera.
1. Install Gigabit Ethernet network card and configure network card.
2. Install Vimba.
3. Connect the camera to PC or laptop and ensure that the camera is powered.
4. Acquire your first image with Vimba viewer.
Installing a GigE network interface card (NIC)
If your host computer has an available Ethernet interface, this can be used with
Allied Vision GigE cameras. We recommend that your camera system uses a
dedicated Ethernet interface not shared with Internet or local area networks. If
more interfaces are needed, or your existing Ethernet adapter is unable to
operate at Gigabit Ethernet speeds, installing additional hardware may be
required.
• For desktop systems, use a PCI Express bus Ethernet adapter.
• For laptops, use an expansion slot via an Express Card.
9