Dyna-Glo Pro RMC-KFA45DGP-01 Manuel De L'utilisateur Et Instructions D'utilisation page 6

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
2. ASSEMBLY
For RMC-KFA45DGP-01/75TDGP-01 Models only
Tools Required
• Medium Phillips Screwdriver.
1. Assembling Handle & Cord Wrap
1) Lift front guard for arrow direction and make
sure that guard's wedged portion fits into the slit
hole on the upper housing.
2) Align the holes in the upper housing with ttwo
mounting holes on the handle as shown in Figure 6.
3) Secure handel with Screws with provided.
4) Insert card wrap into the rectangle holes on the
supportor and align the hole on the cord wrap with
the mounting hole on the side cover as shown in
Figure 6. (75TDGP-01 Model only)
5) Secure cord wrap with Screws with provided.
For RMC-KFA125TDGP-01/210TDGP-02 Models only
Tools Required
• Medium Phillips Screwdriver.
• 19 Socket Wrench
1. Assembling BTU Control Valve.
(210TDGP-02 Model only)
1) Align slit hole on body of Valve with Tab on the
End Filter Cover as shown in figure 7.
2) Insert hooked leg of valve fully into slot of End Filter
Cover so that hooked leg is completely locked to Slot.
NOTE : When install valve to End Filter Cover, If valve
is assembled for incorrect knob direction, Hooked leg is
not completely locked to slot.
2. Assembling Handle & Wheel and Cord Wrap
1) Slide axle through wheel support frame.
Install wheel bushings and wheels on axle
2) Attach Cap Nuts on axle ends and tighten with
Socket Wrench.
3) Place heater on wheel support frame. Align the
holes on fuel tank flange with holes on wheel
support frame.
4) Position the Handles on top of fuel tank flange.
Insert screws through handles, fuel tank flange and
wheel support frames as shown in Figure 8 and
attach nut finger tight after each screw is inserted.
5) Align the hole on the handles with the mounging hole on the Cord Wrap.
Insert Screws through Cord Wrap, handles and attach nut finger tight after each screw is inserted.
6) After all screws are inserted, tighten nuts firmly.
3. Assembling Louver (RMC-KFA210TDGP-02 Model only).
1) Remove two screw in each side fore-end of upper shell.
2) Fit Bracket-Right & Left to each side flange of upper shell and align the each hole on the brackets with
the hole on the flanges(See Figure 8, Page 6).
3) Secure each hole with a screw that removed.
Handle
Suppotor
Figure 6. Assembling Handle & Cord Wrap
BTU Control Valve
End Filter Cover
Tab Slit Hole
Slot
Hooked Leg
Figure 7. Assembling BTU Control Valve
(RMC-KFA210TDGP-02 Model Only)
5
Screw
Frong Guard
Wedged Portion
Slit Hole
Cord Wrap
Side Cover
Screw
Knob direction when install
valve to End Filter Cover.
correct
Incorrect