Dyna-Glo Pro RMC-KFA45DGP-01 Manuel De L'utilisateur Et Instructions D'utilisation page 13

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
F.) SPARK PLUG
CLEAN AND REGAP EVERY 600 HOURS
OPERATION OR REPLACE AS NEEDED.
(For RMC-KFA75TDGP-01/125TDGP-01 Models Only)
- Remove upper shell (See page 10).
- Remove fan (See page 10).
- Remove ignition wire from spark plug.
- Remove spark plug from burner head using medium
phillips screwdriver.
- Clean and regap spark plug electrodes to 3.5mm gap.
- Reinstall spark plug in burner head.
- Attach ignition wire to spark plug.
- Reinstall fan and upper shell.
(For RMC-KFA210TDGP-02 Model Only)
- Remove upper shell (See page 10).
- Remove fan (See page 10).
- Remove ignition wire from spark plug.
- Remove spark plug from spark-bracket using medium
phillips screwdriver.
- Clean and regap spark plug electrodes to 3.5mm gap.
(0.138 )
- Reinstall spark plug in spark-bracket.
- Attach ignition wire to spark plug.
- Reinstall fan and upper shell.
G.) PHOTOCELL
CLEAN PHOTOCELL ANNUALLY OR AS
NEEDED.
- Remove upper shell (See page 10).
- Remove fan (See page 10).
- Remove photocell from it's mounting.
Clean photocell lens with cotton swab.
TO REPLACE:
- Remove side cover screws using medium phillips
screwdriver.
- Disconnect switch wires from power switch and
remove side cover.
- Disconnect wires from circuit board and remove
photocell.
- Install new photocell and connect wires to circuit
board.
- Replace switch wires to power switch and side cover.
- Replace fan and upper shell.
Figure 19. Spark Plug Regap
Figure 20. Spark Plug Regap
Side Cover
Incorrect
Figure 21. Photocell Replacement
12
Spark Plug
Ignition wire
Burner Head
Spark Plug
Bracket Burner
Bracket Spark
Spark Plug
Ignition Wire
Power
Switch
Screw
Switch
Photocell
Wires
Wire
Bracket
Photocell
Lens
Correct