USING THE RACK DRY
1. Open the dryer door.
2. Position the drying rack in the tumbler, placing
the front lip of the drying rack on the top of the
lint fi lter.
3. Place the rear legs in the two recessed areas
of the dryer's back wall and push the middle of
the drying rack down to fi x it in place.
4. Place the items to be dried on the rack, leaving
space between them so air can circulate.
5. Close the dryer door.
6. Tap the Time Dry button in the Cycle pane
of the Cycle Selection screen. Note that the
Rack Dry option is only available in the Time
Dry cycle.
7. Tap the Extras section in the Option pane.
8. Tap the Rack Dry button in the Extras section.
9. Select the time according to the moisture and
weight of the item.
10. Tap the OK button to apply the changes.
11. Press the Start/Pause button to start drying.
To dry items made from materials that are vulnerable to heat such as foam rubber, plastic
and rubber, use the Air Fluff cycle. If you dry these kinds of items by applying heat, the
WARNING
product may be damaged or a fi re may occur as a result.
Never use the drying rack with any cycle other than the Rack Dry cycle.
WARNING
CHECKING THE FILTER
Checking the fi lter
The fi lter check notifi cation pops up before the
cycle you've set begins, reminding you to check
the dryer's fi lter.
Cleaning the fi lter
Clean the fi lter to shorten drying time and operate the dryer with greater energy effi ciency.
Do not operate your dryer without the fi lter in place.
DV457E1_02836J-04_EN.indd Sec3:45
DV457E1_02836J-04_EN.indd Sec3:45
Drying a load of laundry _45
2013-08-08
2013-08-08
4:25:44
4:25:44