Joycare ALLEGRO JC-1221 Mode D'emploi page 11

GB
To adjust the baby seat safety belts to shoulder height and insert them in the appropriate pair of
holes/eyelets, they need to be detached from the hook (L) as shown in Fig. 7/b.
GUIDELINES FOR CORRECT WEIGHT-HEIGHT CORRESPONDENCE
BABY SEAT SAFETY BELTS (See Fig. 8)
The two lower levels of holes are suitable for children weighing up to 6 kg.
The middle holes are suitable for children weighing approx. between 6 and 12 kg.
The top holes are suitable for children weighing approx. between 12 and 18 kg.
WARNING: The baby seat safety belts should not be positioned lower than the
baby's shoulders.
FITTING INTO THE CAR - GROUP 0+ (For children from 0 to 13 kg)
REARWARDS FACING ONLY
Warning: DO NOT place the child seat in the front seat if equipped with air bags.
Otherwise, in the event of an accident, it may cause serious injury or death.
NOTES: The car safety belt must be pulled tight, making sure that it is not twisted. Ensure the
airbag is disconnected.
Step 1
Group 0 - the car seat should only be used in the most reclined position. (See fig. 1/a).
The child seat should never be used in any other position (fig. 1/b).
To adjust the seat to the maximum inclination for group 0, pull the red handle (J) forward until it
stops. The car seat must be used for group 0, only rear-facing and fully reclined, the only position
allowed. (Fig.2)
Step 2
The seat must always be rear facing (Fig. 3).
If your car has a passenger airbag that cannot be deactivated, only use the car seat in the back seats
of the vehicle (Fig. 1/c).
Step 3.
Secure the child car seat on the car seat using the car seat belt (see Fig. 3).
The loops where the car seat belts need to be inserted, both over lap and shoulder, are marked with
blue symbols for group 0.
Step 4.
Lead the lap section of the seat belt under the base of the child seat at the two points marked by a
blue label (A).
11