Parts Required - Stiga Escalade Sports T8579W/F Manuel Du Propriétaire

IMPORTANT NOTE: Place table half top with playing surface face down on a CLEAN flat surface
for ease of correct assembly and to prevent any scratches or blemishes to the playing surface.
1 pc
2 pcs - P2 Leg with Casters Assembly
4 pcs -
2 pcs - C1 Leg Leveler
STEP 1:
Lay one piece P1 Table Tennis Table Top Frame Assembly flat with playing surface
facing down as shown in FIGURE 1A.
Unlock the SAFETY LOCK as shown in DETAIL A and raise FRONT LEGS to a
vertical position and lock both hinges as shown in FIGURE 1B & DETAIL B.
Install C1 Leg Leveler onto each front leg.
This end is the front
of the table.
FIGURE 1A
DETAIL B
Hinge Locked
STEP 2:
Install P2 Leg with Casters Assembly with P3 Connectors
using H1 Bolts, H2 Flat Washers and H3 Lock Nuts
TM
as shown in FIGURE 2 & DETAIL C. Tighten this hardware.
Repeat procedure for other table top.
FIGURE 2

PARTS REQUIRED

P1 Table Tennis Table Top Frame Assembly
-
P3 Connector
Front Leg.
P1
This end is the middle of the table
and does not have white screen
lines and close to Safety Latch.
C1
- 4 -
4 pcs - H1
TM Bolt
8 pcs - H2 Flat Washer
4 pcs - H3 Lock Nut
DETAIL A
Safety Lock.
Push down on LOCK TAB
to release lock and pull up
on FRONT LEGS only.
Do not pull up middle legs
as this could cause damage
to the table.
Front Leg.
DETAIL C
P2
H2
H3
Middle Leg.
FIGURE 1B
H1
H2
P3