CAPITAL SPORTS CROSS PRO Mode D'emploi page 22

Step 4
• Feed the pulse sensor wires (40) through hole in front
of the console mast (2), and pull out off the mast top;
• then fix the stationary handlebar (8) to the mast (2) with
the Allen bolts (15/33), flat washers (13), and acorn nuts
(14).
Step 5
• Insert the plastic pivot washer (30) and the rock arm (12R) to the pivot, secured with the big washer (29), pivot
spacer (28), small washer (27), and the nylon nut (26) as shown.
• Then cover the pivot plug (25). Follow the same steps at the Left side.
22