eQ-3 WFC 300 Manuel D'utilisation page 20

Reception test
• Press the <+> button for at least 3 seconds to activate the
test for the reception of weather data. The text "test" is
shown on the display. The reception indicator for the weather
data shows the quality of reception. The reception is good
if the indicator is shown, otherwise a new location must be
found for installing the weather station.
• The reception test is either ended after approx. 1 minute
automatically or by actuating the <+> button.
6. Operations
Alarm function
• Press the <ALARM> button for at least three seconds to
set the alarm time. The text "ALM" and the hours display
flash. Use the <+> button for the hour setting. By pressing
the <ALARM> button again, the minute setting is activated.
The minute display flashes. Use the <+> button for the
minutes setting. Press the <ALARM> button again to end
the setting mode for the alarm time.
• Use the <ALARM> button to activate or deactivate the
alarm. When the alarm is active, the alarm symbol "((( • ))"is
shown on the display.
• The alarm signal can be interrupted with the <ALARM>
button. Use the <SNOOZE> button to stop the alarm signal
for five minutes. During this time, the alarm signal "((( • ))) "
flashes.
Show current weather region
Press the <SET> button to show the current weather region.
The text „loc" appears with the currently defined region on the
display. An overview of the coding of all available regions can be
found under Appendix.
0