Changing The Direction Of Opening The Door; Mounting The Appliance - Gorenje RFI4151AW Notice D'installation

the rear of the appliance.
• At the base of the kitchen unit intended for building in the integrated appliance, there should be at least 200
cm² free space, for adequate air circulation.
• On the upper part of the appliance the air is coming out, so try not to cover the opening for the outfl ow air.
II.

Changing the Direction of Opening the Door

If you fi nd the direction of opening the door on your appliance inconvenient, you can change it. Holes on
the opposite side have already been prepared in the factory and are now plugged.
• Remove the cover on the upper hinge, unscrew the hinge and take off the freezer door (the door is not
fi xed on the middle hinge), don't forget to remove the washer from the middle hinge.
• Unscrew the upper rail, replace it to the opposite side of the appliance and fi x it.
• Unscrew the lower hinge with the washer and remove the refrigerator door.
• Unscrew the middle hinge.
• Take off all door corners and interchange them (instead of the corner with a hole insert the one without
the hole and vice versa).
• Remove the washer from the lower hinge and unscrew (rotate it in clockwise) the fastener on the lower
hinge. Fix the lower hinge, without the fastener.
• Replace the fastener and the washer in reverse order into the opening of the lower hinge on the op-
posite side of the appliance.
• Put the refrigerator door on the lower hinge.
• Rotate the middle hinge for 180°, replace it to the opposite side of the door and fi x it. Put on the washer
fi rst and then the upper door.
• Fix the upper hinge and cover it.
• Replace the slide guides to the opposite sides of both doors.
• Plug the remaining holes with decorative caps.
• Check the gasket, it shouldn't be creased and it should seal well. In case it does not fi t perfectly, pull it
out and rotate for 180°.
• In certain models it is not possible to replace the door gasket.
• Should the seal not adhere to the casing of the appliance perfectly, it will have to be heated from a suit-
able distance (by means of hair drier, for example) and lightly stretched to the required height.
1 Cover for the upper hinge
2 Upper hinge
3 Upper rail
4 Middle hinge
5 Middle hinge washer
6 Lower hinge
III.

Mounting the Appliance

• Push the appliance for some 38 mm into the kitchen unit and allow at least 4 mm free space on both
sides between the appliance and the side walls of the kitchen unit (Fig. 1).
• Widely open both the doors and put them together with the door of the kitchen unit. The procedure is
as follows:
• Fix the slide guides (attached in a plastic bag along with the screws ST 4,2 x 9,5) to the edge of the door.
7 Lower hinge washer
8 Lower hinge fastener
9 Slide guides
10 Corner without a hole
11 Corner with a hole
5