If The Refrigerator Can Not Pass Through A Door During Installation, Follow These Steps - Gorenje NRS 9181 CBBK Notice D'utilisation

If the refrigerator can not
pass through a door
during installation, follow
these steps.
(This guide refers to several models. The real features are
model dependent..)
Removing Freezer Door
※Remove front bottom cover first, if it is attached.
Pull out bending tube guide and the left water tube.
1
(Dispenser Models Only)
2
Unscrew top hinge cover with a screw driver.
3
Turn top hinge fastener counterclockwise 3~4 times.
Disconnect the harness wires.
4
Lift up the front of hinge to remove. (After the hinge is
removed the door can fall down forward. Be careful!)
5
Be careful not to damage the water line when removing
the door.
Removing Refrigerator Door
1
Unscrew top hinge cover with a screwdriver.
Insert a thin screwdriver into the
side groove of the cover to remove.
2
Turn top hinge fastener counterclockwise 3~4 times.
Disconnect harness wires (model dependent).
3
Lift the door straight up to remove.
Replacing Freezer Door
1
Insert the water tube into the hole of the bottom hinge
pin first.
2
Let the top of the door close and insert the top hinge
pin to the top hole of the freezer door.
(Insert the back of hinge to the groove of protrusion
first, then front to the top hole of door.)
13